|
Choose More> Advanced > Flow Control > Smart Flow Control: 1. Enabling Smart Flow Control: Click Enable and set the network bandwidth provided by the ISP. After the configuration is saved, the router adjusts the bandwidth of each client based on the total bandwidth to prevent anyone client from occupying too much bandwidth.   Note: After smart flow control is enabled, speed measurement will be affected. Disable flow control if you want to do speed measurement. 2. Custom Policy : You can configure custom policies to allocate bandwidth to specific IP addresses/ranges to meet the bandwidth needs of specific users or servers. Click Add on the Custom Policy page to set the policy name, specific IP address/range, bandwidth type, and uplink/downlink rates. The following picture depicts an example of limiting the bandwidth of 192.168.110.64 to 1Mbps at both uplink and downlink.  Bandwidth type: Shared indicates that all IP addresses share the total bandwidth. Independent indicates that the rate limitis set per IP address. CIR indicates the committed information rate. PIR indicates the peak information rate. |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 5
