AutoNat 67
|
What is AutoNat 66 in ruijie router ew-1300G firmware...by default it is disabled.. what is the benefits of it if I make it enable .. which option should configure for gaming ..need low latency |
|
Dear User, The AutoNat 66 is for IPv6-to-IPv6 Network Address Translation. It maps one IPv6 address (or address range) to another IPv6 address (or range) while preserving end-to-end IPv6 communication. Unlike IPv4 NAT, which often functions due to limited IPv4 addresses, NAT66 is not commonly used for address conservation but might be employed for: Renumbering networks. Privacy purposes. Simplifying certain configurations. For low latency, you may consider enabling hardware acceleration. This improves the overall performance, reduces latency, and increases the throughput of the router. |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
