Login Register
 Forgot password?
 Register now

Welcome to use this form to feedback your problems with Ruijie Community

The category of your feedback

Your Feedback

Your Email address (optional):

Other Community
Filter
Official
Why does the MTU need to be modified in QinQ isolation scenario? Reply

admin

Level 4

Back+ Ask a related question
Why does the MTU need to be modified in QinQ isolation scenario?
6321 1 2017-5-3 17:45:46
Original
Why does the MTU need to be modified in QinQ isolation scenario?

scenario
Reply Helpful(0)
All replies (1)
  • Subscribe
0 2017-5-3 17:45:57 View all replies
The reason is as follows:
  • In the QinQ scenario, the distribution device adds a two-layer tag to a packet. Compared with the default MTU 1518 on the Ethernet, a four-byte tag is added. To facilitate operation and ensure redundancy, the MTU is uniformly changed to 1530.

Which devices and interfaces need to modify the MTU?
  • The MTUs of the core interfaces of the upstream aggregation devices and core aggregation interfaces should be set to 1530.

Reply Helpful(0) Recommended
Related Posts
Product Model
Other

Share this topic to

Cancel

This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.

More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.

©2000-2023 Ruijie Networks Co,Ltd