|
To obtain the MAC address of anAP, use any one of the following methods: (1) View the MAC address from thelabel attached to the AP cover. (2) Run the show verison all or sho ap-deviceinformation command on the AC. (3) Log in to the AP and view theMAC address of the physical port. Typically, the AP's MAC address is the MACaddress of the physical port minus 1. (4) Run the show mac-address-table int gi0/Xcommand on the access switch. Xindicates the interface ID. Note: An AP has two MAC addresses. One is the layer-2 MAC address, and theother is the layer-3 MAC address. In the AP label and AC online information,the layer-2 MAC address is displayed. In the MAC address list in the switch,ARP information, and DHCP information, the layer-3 MAC address is displayed. Alayer-3 MAC address has one more bit than a layer-2 MAC address. |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
