Config Vlan trunk between two switch NBS-3200 and ES208 does not work
|
Dear supporter, I have following device: RG-NBR6205, RG-NBS3200, RG-208GC. I've aleady created sub interface with VLAN on NBR6205 Vlan1-3, NBS3200 port 24 as Trunk port allow, Vlan1-3. I also configured NBS3200 port No.23 as trunk port allow Vlan2 and connected directly to RG-208 port No.8. RG-208 port No.8 also configured trunk Vlan2. But it seems that it did not work. Can you help me ? Thankyou! |
|
Hi Tinh, In my understanding, your topology looks like this:  Could you please give me the "show run" configuration on all the switches? We will then see what you are configuring on each port. |
|
Hello Sir, You can contact us on RITA at any time, we can help you to check your configurations to solve the issue. RITA (Ruijie Intelligent Technical Assistant) Regards! |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
