|
The NAT Inside Interface Is Configured on the virtual-temp Interface on the LNS. The NAT Does Not Take Effect After the Client Dial-up Is Successful. |
|
[Operation Steps] The NAT inside interface is configured on the virtual-temp interface after the client dial-up is successful. [Fault Cause] After the client dial-up is successful, one virtual-access interface is generated on the LNS. This interface is used for interworking with the client and its configuration is inherited from the configuration of the virtual-temp interface upon successful dial-up. The NAT inside interface is not configured during client dial-up. Therefore, the configuration of the virtual-access interface does not contain NAT inside interface. As a result, the preceding fault occurs. [Solution] Make the client go offline and then perform dial-up again. Then, a virtual-access interface will be generated and the interface configuration will be loaded from the configuration of the virtual-temp interface. |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 4
