|
Problem Description： There are three ACs on a VAC, but APs are all connected to one of the AC.  Topology：  Troubleshooting Step： 1. Check the aggregate port setting on core switch. Need set its load balance by source IP and destination IP. You can use the following command to configure it. Ruijie#configure ter Ruijie (config)#aggregateport load-balance src-dst-ip Ruijie (config)#end Ruijie#wr 2. Check whether core-switch is on VSU mode. If yes,you to disable local priority forwarding by using the following command: Ruijie#configure ter Ruijie(config)#switch virtual domain 1 # 1 is the domain-id of VSU Ruijie(config-vs-domain)#no switch virtual aggregateport-lff enable Ruijie(config-vs-domain)#end Ruijie#wr Verification: After setting, APs load balance successfully , you can see the following result:  |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
