How to Config Weight For Load Mode Primary & Secondary
|
If have 2 ISP ... Wan0 = 500 MB And Wan1 300 MB Question 1 Router set config ( For Load Mode Primary & Secondary ) Wan 0 = Set as Primary Interface and Wan1 =Secondary Interface So .. How to Config Wan0 Weight = xxxx ? How to Config Wan1 Weight = xxxx ? Question 2 Router set config ( For Load Balanced ) Wan 0 = Set as Primary Interface and Wan1 =Secondary InterfaceSo .. How to Config Wan0 Weight = xxxx ? How to Config Wan1 Weight = xxxx ? |
Hi sir, sorry for not reply timely, you may refer to the below picture. if Wan0 = 500 MB And Wan1 300 MB, then we suggest WAN0:WAN1 =5:13 |
GTAC-Wayne replied at 2022-8-25 15:06 Thank you so much Balanced mode and Primary & Secoundary mode All Mode suggest WAN0:WAN1 = 5:13 If Wan0 = 5 MB And Wan1 3 MB Suggest WAN0:WAN1 = 5:13 ? |
mr.hall replied at 2022-8-25 15:34 If Wan0 = 5 MB And Wan1 3 MB Suggest WAN0:WAN1 = 5:3. the weight ratio == the ratio of two WANs |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
