Question about documentation or functionality

Good day!
I have a question about configuration or it's capabilities on this equipmet.
Usually it's looks like this:
-------

en
conf t
int GigabiteEthernet\FastEthernet\other interface  0/1-48.1-200
-------
The hardware itself configures this logical interface.
I have a question if this functionality is included in this model.

Or is there documentation on this equipment, I would be grateful if someone refers to it.

Thank you in advance.

Dear sir

You can configure sub-interface using these commands on the switch:
ruijie>enable

ruijie#conf t

ruijie(config)#interface TenGigabitEthernet  0/10
                       no switchport

                       exit

ruijie(config)#interface TenGigabitEthernet  0/10.1
                         encapsulation dot1q 10
                         ip address 1.1.1.1 255.255.255.0

Best regards
Jenny

GTAC-Jenny replied at 2022-11-3 09:35
Dear sir

You can configure sub-interface using these commands on the switch:

Usually an interface is created, but apparently this functionality is not supported on this model


Because of this, I raised the issue of the ability to configure a subinterface


Thank you Jenny, but it's not working



If someone can say for sure whether the functionality is included in this model or not, it would be nice



Also, I could not find documentation on the models, except for the data sheet...

Danil Seryshev replied at 2022-11-3 16:30
Usually an interface is created, but apparently this functionality is not supported on this model
...

Dear sir

Sorry as I further check that the DCN switches in 11.x version can support sub-interfaces, for example, N18-X/6220/6220-H/6510/6520/6250. While the S5760C-48GT4XS-X is campus switch does not support sub-interfaces. Sorry for the inconvenience.


Best regards

Jenny

GTAC-Jenny replied at 2022-11-3 17:16
Dear sir

Sorry as I further check that the DCN switches in 11.x version can support sub-interface ...

Thank you, issue closed