If the interface looks like the following, device is in beta mode. You can change mode by entering the user modeconfiguration command: （1) press ctrl+c，enter bootloader memu； （2）key in“4”， ===》4.scattered utilities. （3）key in“3”， ===》3. advanced settings. （4）key in“6”， ===》6. Set RGOS mode. （5）show : Switch RGOS to user mode. Erasing SPI flash...Writing to SPI flash...done （6）reboot or ctrl + z to enter the first level, select the run 2 main can be restored. |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 5
