|
You can enable Layer 2 isolation for wireless user VLAN on AP with the following commands: Fit AP (Enter the following command on AC): AC (config) #wids -----> enter wids configuration mode AC (config-wids) #user-isolation ssidd-apenable ----- > Configure WLAN-based user isolation under AP AC (config-wids) #user-isolation ap enable -----> configure user isolation under AP AC (config-wids) #user-isolation ssidd-ac enable -----> configure WLAN-based user isolation under AC AC (config-wids) #user-isolation ac enable -----> configure user isolation under ACAC (config-wids) #end AC#write Fat/MACC AP: Ruijie #configure terminal Ruijie (config) #wids -----> enter widsconfiguration mode Ruijie (config-wids) #user-isolation ssid-ap enable -----> configure WLAN-based user isolation under AP Ruijie (config-wids) #user-isolation ap enable -----> configure user isolation under APRuijie (config-wids) #end Ruijie #write |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 5
