Forgot password?
 Register now

Welcome to use this form to feedback your problems with Ruijie Community

The category of your feedback

Your Feedback

Your Email address (optional):

What is the difference between DLDP and BFD? Reply

GTAC-Sophia

Level 5

Ruijie Staff

What is the difference between DLDP and BFD?
1819 0 2023-4-14 16:20:21
Original
1. DLDP can be used only on Ethernet interfaces. BFD can be established between any two neighbors.
2. DLDP uses ICMP packets for detection. BFD uses its protocol to detect packets.
3. DLDP is a one-way detection behavior and can be used in one direction. BFD is a bidirectional detection behavior and needs enable BFD at both ends.
4. DLDP is based on an interface. That is, after detection fails, the interface (SVI, no switch port, and Layer-3 AP interface) is logically shutdown. BFD detects the connectivity between a neighbor pair and processes only the route entries associated with the BFD.
RG-S5300-48GT2SFP2XS-E

Technical Introduction Switch
There are no replies.
Related Posts
Product Model

Share this topic to

Cancel

This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.

More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.

©2000-2023 Ruijie Networks Co,Ltd