The following example shows how to configure interface F0/1 as the access port and assign interface F0/1 to VLAN 100 Ruijie>en Ruijie#conf t Ruijie(config)#interface fastEthernet 0/1 Ruijie(config-if)#switchport mode access Ruijie(config-if)#switchport access vlan 100 Ruijie(config-if)#end Ruijie#wr |
Make sure to adapt the configuration to your specific interface and VLAN requirements. Additionally, it's always a good practice to save the configuration to ensure that your changes are persistent after a reboot. |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd