What can I do for the initial setup of the Ruijie EG series gateway using the Web management UI?

Web service is enabled for the RG-EG series by default.
1. Connect your PC to EG and ensure that the EG gateway can be pinged successfully from the PC.
2. Enter the IP address of the LAN interface, WAN interface, or management interface of the EG router in the address bar of the browser. The IP address of your PC must be in the same network segment as the IP address of the EG device.
The default Web management address is http://192.168.1.1 when the device is reset or is used initially.
If the HTTPS protocol is used, the initial management address is https://192.168.1.1:4430.
3.      Access the system login UI. The default username and password are both 'admin' when the device is reset or is used initially.
4.      The EG device is not configured when you log in to the Web management UI for the first time. You will enter Config Wizard to reset the administrator password, select the scenario, enable smart flow control, and configure WiFi
1) Reset Password:

2) Select Scenario:

3) Configure Interface:

4) Enable Smart Flow Control:

5) Configure Wi-Fi:

6) Save Configuration:

Note: Wi-Fi settings will be displayed only if the device supports Wi-Fi.