How to configure RIPng advance functions on NBS Series Switches?(ReyeeOS 1.218.2421)

1. Configuring the RIPng Global Configuration

You can Click [Device]> [Routing]> [RIPng Settings] > [Advanced], Click [Edit Config]





Route Advertisement: After route advertisement is enabled, the current device generates a default route and sends it to the neighbor.

Administrative Distance: Redistribute routes of other protocols to the RIP domain so that RIP can interwork with other routing domains.

Update Timer： RIP update cycle. The routing information is updated every 30 seconds by default.

Invalid Timer： If no update is received before a route becomes invalid, the route is considered unreachable. The default value is 180 seconds.

Flush Timer: If no update is received before the flush timer of an invalid route expires, the route is completely deleted from the RIP routing table. The default value is 120 seconds.


2. Configuring the RIPng Route Redistribution List

You can Click [Device]> [Routing]> [RIPng Settings] > [Advanced], Click [Add]



Type: Direct Routing/ OSPF Routing/ Static Routing

Administrative Distance: Value range: 0-16. The default value is 0.


3. Configuring the RIPng Passive Interface

You can Click [Device]> [Routing]> [RIPng Settings] > [Advanced], Click [Add],and enter the IP address of the neighbor router.





4. Configuring the IPv6 Aggregate Route

You can Click [Device]> [Routing]> [RIPng Settings] > [Advanced], Click [Add]. and enter the IPv6 address and prefix length (value range: 0–128).