|
How to fix when modification to the non-root AP do not take effect on the AC? |
|
All the commands for modifying the non-rootbridge configuration take effect only after the wds config commit command is run. In ap-configmode, run the wds config [ clear |commit ] radio radio-id command. The parameters are described below: clear: Clears WDS configuration that does nottake effect. commit: Commits WDS configuration that doesnot take effect. After the operation, the bridge is disconnected and thenconnected. radio radio-id: Indicates the radio IDconfigured on the AC. If the AP is in non-root mode, its radioenters the wds edit mode. At this time, most of wds commands do not take effectimmediately. You can run the show ap-config wds-config command to display theconfigurations. After confirming that the configurations are correct, run thiscommand to commit the modification. |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 4
