|
You can check the interface usage on the Ruijie switch as follows: S5310# en S5310# conf t Enter configuration commands, one per line. End with CNTL/Z. S5310(config)# show interface gigabitethernet 0/1 usage Interface Bandwidth Average Usage Input Usage Output Usage ---------------------------------------- ----------- ---------------- ---------------- ---------------- GigabitEthernet 0/1 1000 Mbit 0.01% 0.00% 0.01% Note: bandwidth refers to the actual link bandwidth, not the configured value of bandwidth on the interface. |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
