|
Why is the console hanged after a stand-alone system is configured in the VSU mode? |
|
According to normal operation habits, generally, the network administrator adjusts the baud rate to 115200 baud and saves the configurations. After a stand-alone device is changed to the VSU mode, the device loads the VSU configuration template instead of that of the stand-alone device. If the VSU mode is initially configured, the baud rate is 9600 by default. After the device is switched over and restarted, you cannot access the system and the CLI is hanged, caused by different baud rates. In such a situation, you need to adjust the baud rate to 9600. |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 4
