RG-EG210G-P load balancing and aggregation

Hi guys,
I have a RG-EG210G-P router and i am using 4 WAN links. They are set to Primary/Secondary. 3 x WAN ports set as primary - WAN+WAN1 is a single ISP with 2 x 100MB links. WAN2 is a backup 15mb link from a different ISP and WAN4 is a 4G router set as secondary should ALL other links fail.

I previously had 2 x 50MB links on WAN+WAN1 and with the WAN2 @ 15mbs i do a speed test and i get 115Mbs - an aggregation of all 3.
Today i upgraded the speed on WAN+WAN1 to 100Mbs and expect on a speed test 215Mbs - BUT only getting 100mbs! if i test each link alone i get the speed they should be rated. BUT i am not getting the aggregation.
Should i be doing something differently or some sort of config etc?

Hi sir
For this situation , you can check your load balance config.
Step 1. check the load balance mode.

Step 2. check the load balance policy .Different policies will prevent traffic from being loaded to other links.

GTAC-Tom replied at 2024-8-3 00:33
Hi sir
For this situation , you can check your load balance config.
Step 1. check the load balance ...

AH ok - let me try that.
Also, i don't have any polices loaded - are there any default policies i should change OR if i didn't add it should be clear?

GTAC-Tom replied at 2024-8-3 00:33
Hi sir
For this situation , you can check your load balance config.
Step 1. check the load balance ...

Thank you working MUCH better!

User 37656 replied at 2024-8-3 01:47
Thank you  working MUCH better!

You are welecome