Configure mesh on RG-EW1200
|
Hello these, I just bought 3 EW1200, I want to configure mesh following pic below. 1 Master - Ground Floor. Slave 1 - First Floor. Salve 2 - Second Floor. However, Slave 2 is too far Master. Any solution to configure? Or can I configure mesh between Slave 1 and Slave 2. Many thanks for your advice !!  |
|
Dear Khoa, The slaves will be connected to the master. It is not possible to add a slave to another slave. What you can do is increase the transmission power of the radio frequency of the master and the second slave so that the values between them are optimal. Best Regards |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
