Keywords: IPsec VPN, Main Mode 1. Device Model and Firmware
When configuring IPsec or L2TP over IPsec VPN on the NBR router’s web UI, the default negotiation mode for the VPN is set to the aggressive mode. You can find the delivered commands by pressing the F12 key. You can also run the following command on the CLI. Ruijie#showrun | be ipsec pr You cannot change the mode to main mode directly through the NBR router’s web UI, but need to enter the CLI to make configuration changes. The steps are as follows: Run the showrun | be ipsec pr command to view the IPsec profile. Enter the profile configuration mode (copy the profile and paste it in the CLI). Run the show this command to display the profile configuration to verify that the correct profile is copied. Run the following command to change the negotiation mode from aggressive mode to main mode. set exchange-mode main After changing the configuration, running the show this command does not display the configured main mode command. This is because the main mode is the default working mode of IPsec on the NBR router. Save the changes. |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd