CAPTIVE PORTAL

Good day.
I want to sell WiFi vouchers at my restaurant. I have Reyee RG-EG105G-P, RG-RAP6202(G) access point, and a 3rd party TP-Link AP. Is it possible to create a captive portal using the Reyee RG-EG105G-P and start broadcasting the authenticated WiFi at network level, whereby any 3rd part access point can be connected to the LAN port of the Reyee RG-EG105G-P
and broadcast the authenticated WiFi.

Dear customer
For our EG device and AP you can follow this guide to config the SSID and captive portal
1.Create a new vlan id and new SSID for the captive portal user





2. create captive portal policy bind this SSID and ip segment









3. For the auth method you can set at the captive portal page



4.Create the auth account







5. For third AP device , you can collect to the Lan port and config the vlan id link this one
Confirm the vlan 100 and gateway have configed at the EG device


At the port connect to Third AP, you can config the port follow this one. Only permit vlan 100. If yoy want permit more vlan id you can change the config keep same with another port.

If the Third-part AP user can get vlan 100 192.168.100.x/24 ip address, will use the captive portal auth.
Best Regards
Tom

GTAC-Tom replied at 2024-10-24 19:09
Dear customer
For our EG device and AP you can follow this guide to config the SSID and captive por ...

Thank you for the configuration steps. I also have another question. How can I block people using VPNs (like Thunder VPN, Psiphon etc), from freely using the internet?