|
Static routes are manually configured by the user. When a data packet matches a static route, the packet will be forwarded according to the specified forwarding mode. Caution: Static routes cannot automatically adapt to changes of the network topology. When the network topology changes, you needto reconfigure the static routes. Configuring IPv4 Static Routing Choose One-Device > Gateway > Config >Advanced > Routing > Static Routing Click Add. In the dialog box that appears, enterthe destination address, subnet mask, outbound interface, and next-hop IPaddress to create a static route.     After a static route is created, you can find the relevant route configuration and reachability status in the static route list. The Reachable parameter specifies whether the next hop is reachable, based on which you can determine whether the route takes effect. If the value is No, check whether the outbound interface in the current route can ping the next-hop address.  Configuring the IPv6 Static Route Choose One-Device > Gateway > Config >Advanced > Routing > IPv6 Static Routing  (1) Click Add  (2) Configure an IPv6 static route of the device.  (3) Click OK. |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 6
