Forgot password?
 Register now

Welcome to use this form to feedback your problems with Ruijie Community

The category of your feedback

Your Feedback

Your Email address (optional):

Aggregate Interface issue Reply

Ralp Joseph de Guzman

Level 1

Aggregate Interface issue
86 1 2025-7-18 16:43:06
Original
I create a Aggreate interface included port 2 and port 3 but when i integrate to cisco catalyst with Lacp configuration from port 23 and 24 the internet sudden not working.

I tested this before migrating to RG wall 1600-z3200 . example Pfsense port 3 and port 4 as LACP connecting to Cisco Catalyst port 23 and port 24 and it was not working  internet will down.


Looking atleast a tutorial how to configure LACP and Trunk port on RG wall 1600 -Z3200-s i try to read and search to internet for this configuration but can find any documentation.
RG-WALL 1600-S3200

Firewall
0 2025-7-19 12:55:16 View all replies
Hi sir,
do you check the two device can configuration the same mode?
When configuring port aggregation between Cisco and Ruijie devices, the following configurations must be the same:
Basic port properties:
Speed: The port speeds of both devices participating in aggregation must be consistent, such as 100Mbps, 1Gbps, or 10Gbps.
Duplex mode: The duplex mode of the port must be the same and should be set to full duplex mode.
Port link type and VLAN configuration:
Link type: Both ports are Access ports and belong to the same VLAN, or both are Trunk ports.
VLAN setting: If the port is a trunk port, its allowed VLAN and native VLAN attributes should also be the same.
Port aggregation protocol and mode:
Protocol: Both devices must use the same port aggregation protocol. Cisco devices support PAgP (Private Protocol) and LACP (Standard Protocol), while Ruijie devices support LACP. Therefore, it is recommended to use LACP protocol for interconnection between the two.
Mode: When using the LACP protocol, the LACP modes of both ports must match, that is, one end should be set to Active mode and the other end should be set to Passive mode, or both ends should be set to Active mode. If using manual load sharing mode, the configuration at both ends also needs to be completely consistent.
Load sharing mode: The load sharing mode for port aggregation of devices at both ends needs to be consistent, such as load sharing based on source MAC address, destination MAC address, or IP address.

Related Posts
Product Model

Share this topic to

Cancel

This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.

More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.

©2000-2023 Ruijie Networks Co,Ltd