|
I want VLAN 1 go through WAN 1, VLAN 2 go through WAN 2， how can I do it?
You can use the policy route to do it, for example vlan 1 is 192.168.1.0 vlan 2 is 192.168.2.0. WAN 1 is 10.100.10.1, gateway is 10.100.10.254 WAN 2 is 10.100.11.1，gateway is 10.100.11.254
Step 1 click route policy-base route， click add ACL
Step 2, Add two ACL 10 and 11，set ACE to permit 192.168.1.0 and 192.168.2.0
Step 3 Configure Policy route
Finished
|
| I have setup like this but my client seems to skip this rule and they keep go to WAN 1. My device EG-2100 v2p |
adriana.hs599@g replied at 2021-10-7 19:33 Dear sir, The WAN 2 port are reachable right？ And please try to tracert on the client, to check where it can work |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
