How to manage AP/AC devices on the web

Fat AP web management

You can log in to a wireless AP through the WEB as follows:

Step 1: Powering the Access Point

AP  usually  has  two  power  supply  methods: They  are POE  power  supply  and  DC power supply.The factory equipment without power equipment,according to the deployment requirements to choose the appropriate power supplymethod.

1.POEmodule power supply connection diagram

2.POEswitch power supply connection diagram.

3.DC power supply connection diagram

Note: Only part of the AP model supports DC power supply, there will be a corresponding DC interfaceidentifier on the AP panel.

Step 2:WEBinitialization login instructions

AC and AP are the default open WEB management functions, the default management address is 192.168.110.1, and the default login user name and password both are admin.Configure the PC with the same network segment IP (such as 192.168.110.2, the mask is 255.255.255.0), can log in http://192.168.110.1 through the browser.

Enter the user name and password admin and click login

AC web management

Noted：

The default AC management IP address is 192.168.110.1

The default web login user password is admin

Step 1: connect the computer to the AC

Note: When logging in to the AC for the first time, only connect the AC to a PC for logining after powering on the AC. Do not connect the AC to other network devices. Otherwise, IP conflicts may occur with the connected AP and the AC cannot be logged in.

Step 2: Device login

1) The IP address of the computer's wired setting is 192.168.110.2. Subnet mask: 255.255.255.0 Default gateway: 192.168.110.1

2) Call the browser and enter the IP address 192.168.110.1 to log in to the web interface of the device. The default password of the device login user is admin/admin, as shown below