|
After policy-map Is Enabled on an Interface of an RSR Router, How to Check the Traffic Matched in the Default Queue? |
|
Configure a new class-map to match the remaining traffic. Check how much traffic is matched using the new class-map to check how much traffic is transmitted through the default queue. The command for checking how much traffic is transmitted through the new class-map queue is as follows: Ruijie#show policy-map interface gigabitEthernet 0/0 |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 4
