Case Sharing --- 5. Configuration

5.1 EG configuration

WAN load balance

5.2 Switch configuration

Step1: Access to Ruijie Cloud and go to switch’s details

Step2: Configure All the LAN interfaces to trunk, native Id is 1, and allow Vlan 1, 10, 20

Step3: Configure uplink interfaces to trunk, native Id is 1, and allow Vlan 1, 10, 20

5.3 AP configuration

Step1:Configure the Voucher SSID and set the VLAN ID to 10

* Note: TiIf the use the EG local authentication, need to disable theAuth feature on the SSID settings.

Step2: Configure the Staff SSID and set the VLAN ID to 20, the Encryption Mode is WPA/WPA2-PSK.

Step3: Configure the account SSID and set the VLAN ID to 20, enable the Auth feature and select the portal template.

Step4:Display the SSID settings.

5.4 Authentication configuration

Step1: Create 2 captive portal templates, 1 for voucher, 1 for account.

Step2:Click Captive Portal > Synchronize to sync the portal to EG.

Step3:Go to EG eWEB, and enable the Local Server Auth and Auth Integration with Cloud.

Step4:Create the voucher package.

Step5: Create the vouchers.

Step6: Create the account profile.

Step7:Create the accounts.

Step8:Go to EG eWEB, check whether the vouchers and accounts are same as the Cloud.

Step9:Create 2 sub-interfaces, Vlan10 interface and Vlan20 interface.

Step10: Create 2 DHCP pools for Vlan10 and Vlan 20.

Step11:Check whether the portal template is synced to the EG.

Step12: Create the authentication policy.

Step13: Create the advanced settings.