M5100 prompts system error when converted to transparent mode.

M5100 prompts system error when converted to transparent mode.

Check whether the following configuration is done:

1）Remove the LAN interface configuration

Need to delete the relevant configuration may include the following aspects (Equipment factory default comes with firewall strategy and dhcp service of LAN port):

(1) Firewall policy, if the lan port configuration strategy, as the source interface or destination interface.

(2) Static routing, delete the related routing entries of LAN port.

(3) DHCP service.

(4) IPsec, VIP and so on.

(5) Address object.

2）Switch working mode of LAN

In the bottom split LAN port, can through the following order to switch the operation mode of LAN: (need to enter print cliovrd enabl4e first, and then exit and login can enter the following command)

RG-WALL#config system virtual-switch

RG-WALL(virtual-switch)#delete lan

RG-WALL(virtual-switch)#end

3）If the device is p3 version, need to close of the wan1 and wan2 port auto-ipsec attribute at the bottom.