1. Click Router->Advanced->FlowControl->Enable, configure the WAN Bandwidth base on truth, such as ISP give you a cable with uplink 100Mbps and downlink 200Mbps, you can fill up 100and down 100 here, then click Save. Notice: If you want totest the WAN rate, please disable smart flow control first. 2. After enable flowcontrol, you can see a new button CustomPolicy. Click it to allocate bandwidth to the specified VLAN IP address orrange. The priority is sorted as follows: Custom Policy > Smart Flow Control.  IP/IP Range: Set an IP address or IPaddress range. Bandwidth Type: Shared indicates thatall IP addresses share the total bandwidth. Independent indicates that the rate limit is set per IP address. Uplink Rate: CIR: CIR indicates the committedinformation rate. PIR: PIR indicates the peak informationrate. Downlink Rate: CIR: CIR indicates the committedinformation rate. PIR: PIR indicates the peak informationrate. Interface: Select a WAN port which thepolicy is applied to. If choose All WANPorts: The policy is applied to all WAN ports. Status: Enable or disable a policy. 3. Do speed test,showing the guest which on default vlan only can reach under 2Mbps  |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
