How to change the SSID Radio from Radio2(5GHz) to Radio1(2.4GHz)
|
Edited by unknown unknown at 2022-9-30 19:54 Cna I change the SSID Radio from Radio2(5GHz) to Radio1(2.4GHz) by command (like Web CLI)? If yes, please advise the command statement. Thanks. |
|
Dear sir, may i know your AP model? coz only few ruijie AP that support change radios. You can use the below commands to change it if your AP hardware support it. config t TestRuijie(config)#int dot11 2/0 TestRuijie(config-if-Dot11radio 2/0)#radio-type 802.11b Failed to set radio type for unsupported hardware. ---- if not support, will show this msg. |
GTAC-Wayne replied at 2022-9-30 20:31 Thank you for your reply. the model "AP820-L(V2)" |
unknown unknown replied at 2022-10-3 08:34 Hi sir, as checked, this model only support two radios, not support radio 3  |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
