Captive portal is not showing when user tries to connect my SSID

My device is following:

EG105G-P-V2

Here is how I tried to enable captive portal to my SSID.

• Created a SSID by assigning VLAN port 10
• I created a Captive Portal by going Authentication -> Captive Portal -> Add and Save
• On the page https://cloud-as.ruijienetworks.com/admin3, Monitoring -> Device -> Gateway -> Opened SN
• Config -> Cloud Portal Auth
• Enabled Auth and Clocked Add
• Network = VLAN10 and selected my Captive Portal then Clicked Save and Again Save
• Back to Configuration -> Authentication -> Captive Portal
• Click on Synchronize
  
  • My Captive portal is not synchronized. Hence, I clicked on my captive portal clock icon and clicked Ok for Sync the portal to EG.
    
  </li>

I did all the above steps but captive portal is not synchronized and not working.
Did I miss anything?

Dear sir,


You can check your configuration by this link:https://community.ruijienetworks.com/forum.php?mod=viewthread&tid=1759



Best regards,

Steve