Forgot password?
 Register now

Welcome to use this form to feedback your problems with Ruijie Community

The category of your feedback

Your Feedback

Your Email address (optional):

Wireless Communications Basics -- Spatial Streams Reply

GTAC-Sophia

Level 5

Ruijie Staff

Wireless Communications Basics -- Spatial Streams
1882 0 2023-5-29 14:54:19
Original
(1) Background
The spectrum of an electromagnetic wave can be seen as a land and 2.4 GHz band is a road on the land. The frequency range of 2.4GHz–2.4835 GHz is the width of the road. The road can be further divided into lanes (channels) and each lane has a valid width of 20 M Hz. Vehicles can only run on one of these lanes. The number of vehicles running on the road simultaneously is limited because the road is narrow.
(2) MIMO in Wi-Fi 4
In Wi-Fi 4, MIMO (Multiple-Input Multiple-Output) is like an overpass above a narrow road. This is called spatial reuse. In this case, with one more road, the number of vehicles running simultaneously is doubled, greatly improving the transmission rate.

As you may find in advertisements, some routers feature 4X4 MIMO. That means, the router has four Tx/Rx antennas. If a phone or computer supports 4X4 MIMO (having four Tx/Rx antennas), there will be four spatial streams between the router and phone or computer. If a phone supports only 2X2 MIMO, the router and phone will negotiate and agree to use two spatial streams.
Therefore, you may find that the transmission rate is 1200 Mbps although the router supports 4x4 MIMO (up to 2400 Mbps). That is because most phones support only 2 spatial streams. Very few phones support three or four spatial streams because the more the antennas, the higher the power consumption and faster the battery is drained.
(3) MU-MIMO
MIMO in Wi-Fi 4 is also called SU-MIMO (Single-User MIMO) because the router can communicate with only one terminal simultaneously although spatial streams are increased. The router can communicate with another terminal only when it finishes communication with the current one.
MU-MIMO (Multi-User MIMO) in Wi-Fi 5 supports simultaneous data transmission between a router and multiple terminals. However, it supports simultaneous transmission only for downlink data like file download and TV broadcast. Uplink data needs to queue up for transmission.
In Wi-Fi 6, MU-MIMO supports simultaneous transmission of both uplink and downlink data.
RG-EW1200G Pro

Technical Introduction Mesh Wi-Fi
There are no replies.
Related Posts
Product Model

Share this topic to

Cancel

This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.

More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.

©2000-2023 Ruijie Networks Co,Ltd