|
You can configure it according to the following command S5310E(config)#int g0/1 S5310E(config-if-GigabitEthernet 0/1)#no switchport S5310E(config-if-GigabitEthernet 0/1)#end S5310E#write After you have switched, you can check the switchstatus with the following commands: Ruijie(config)#show interfaces gigabitEthernet 0/16 Layer 2 interface  Layer 3 interface  You can use the following command to switch the L3interface to the L2 interface S5310E(config)#int g0/1 S5310E(config-if-GigabitEthernet 0/1)#switchport S5310E(config-if-GigabitEthernet 0/1)#end S5310E#write |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 5
