How do I factory reset the Ruijie AP in fit mode via CLI?

There are 2 scenarios when a customer wants to factory reset the Ruijie AP in fit mode via CLI:

1. When Ruijie AP is online on Ruijie AC, you can login to the CLI of Ruijie AC, and input these CLI commands:

Ruijie>enable

Ruijie#show ap-config summary  //Check the actual name of Ruijie AP you need to reset.

Ruijie#config

Ruijie(config)#ac-controller   

Ruijie(config-ac)# factory-reset ap-name  //The ap-name here is the actual name of your Ruijie AP.

Ruijie(config-ac)# end

Ruijie#write

2. When Ruijie AP is not online on Ruijie AC, you can use this CLI command:

Ruijie(config)# apm factory-reset   //This command can only be used in 11.x firmware of Ruijie fit AP.