Forgot password?
 Register now

Welcome to use this form to feedback your problems with Ruijie Community

The category of your feedback

Your Feedback

Your Email address (optional):

How to activate internal antennas of AP680(CD)? Reply

GTAC-Bancroft

Level 1

How to activate internal antennas of AP680(CD)?
1462 0 2023-8-10 13:59:40
Original
You can follow these steps to activate internal antennas of AP680(CD):

1.Login to the CLI of AP680(CD) and check if the external antenna is enabled or not under radio ports.

2.If external antenna is enabled, please use these CLI commands to turn it off, then internal antenna will be enabled:

Ruijie(config)# interface Dot11radio 1/0

Ruijie(config-if-Dot11radio 1/0)#no external-antenna enable

Ruijie(config-if-Dot11radio 1/0)#end

Ruijie#wr

Note:

The same radio port can only work in the internal antenna or external antenna state.

After switching to the external antenna, the internal antenna will be disabled.

RG-AP680(CD)

Configuration Wireless
There are no replies.
Related Posts
Product Model

Share this topic to

Cancel

This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.

More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.

©2000-2023 Ruijie Networks Co,Ltd