|
1. After changing to AC mode, the EG will automatically restart. After the handover is successful, all interfaces are equivalent to a WAN port. [Case 1]: If the upper gateway has DHCP enabled, EG obtains the address through DHCP. You can view the ip address obtained by EG in the address pool of the upper gateway and log in with this address. [Case 2]: If the upper gateway does not open DHCP, the PC needs to be directly connected to EG, and configure the ip address of the PC to 10.44.77.0/24 network segment, enter the web interface 10.44.77.254 log in to EG in the web browser 2. If EG and AP have formed SON, you can connect the wireless signal of AP, log in to AP with 10.44.77.253, 10.44.77.254, 192.168.120.1, check the IP address of the master device EG in the device list, and log in to EG through this address. |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
