Topology: Requirements Add G1/1 and G1/2 to the aggregation port for switch A. Add G2/1 and G2/2 to the aggregation port for switch B. Then configure them to static LACP Configuration tips: 1. For a Layer-3 device that does not support Layer-2 functions, the AP(aggregation port) is a Layer-3 port. Otherwise, the AP(aggregation port) is a Layer-2 port 2. If you need to change the layer-2 port to layer-3 port, you can use this command: no switchport Configuration steps: Switch A: SwitchA# configure terminal SwitchA(config)# interface range GigabitEthernet 1/1-2 SwitchA(config-if-range)# port-group 3 Switch B: SwitchB# configure terminal SwitchB(config)# interface range GigabitEthernet 2/1-2 SwitchB(config-if-range)# port-group 3 Verification: SwitchA# show aggregateport summary  SwitchB# show aggregateport summary  |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
