port run only 10m
|
hi, some port are running on 10mbps how to know what is the cause ?  |
|
Dear Mobit Ong, May I please know what devices are connected to these ports? Do the peer devices support an auto-negotiation rate of above 10M? You may please replace the cable and check if the port speed can be negotiated normally. If the switch firmware version is not the latest, you may try upgrading the switch firmware to the latest version which you can download from the link below: https://www.ruijienetworks.com/resources/software/rg-es216gc-es224gc-1p21-firmware/rg-es216gc-es224gc-1p21-firmware/ Best regards, Jayden |
GTAC-Jayden replied at 2023-10-29 21:48 Alternative to Jayden's response. You may also check if your cables are terminated correctly. Badly or incorrect cable termination can effect speed. Also check the cable distance it has to travel. |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
