|
Edited by Oscar at 2018-7-5 15:56 Before You Start POE out feature for PD device on outdoor AP630 requires HPOE power supply for RG-AP630, please verify whether the POE switch support HPOE(802.11bt) or not if IP Cam cannot be powered up. 
FAT AP 1. Click Wizard and choose "Bridge Mode" on FAT AP EWEB. 2. Fill in an IP address for AP management. 3. Configure Access Mode(singal service) or Trunk Mode(multi service) on HPOE Switch's port as to allow all service traffic passthrough. FIT AP 1. Ensure AP630 is online on hardware controller and ready to be configured. For more information on how to make AP online, please click here: https://www.ruijienetworks.com/support/documents/slide_58903 2. Edit designated AP and configure VLAN id for these LAN ports on Controller EWEB.
3. Configure the port which is connected to AP630 into "Trunk Mode" (services VLANs need to be allowed) and Native VLAN should be modified into AP management VLAN on HPOE Switch. |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
