|
You can configure it according to the following command AP>enable AP#configure terminal AP(config)#ip ttl 52 -----Set TTL to 52. By default, Ruijie APhas a TTL value of 64 |
|
AFAIK RAP didn't have console Can I run those cmd using web terminal? |
nbctcp bun replied at 2024-6-25 08:37 Hi sir, Yes, it can support. 1.you can use telnet to configure this command.  2.If you your AP doesn't have telnet configuration, you can try using web cli from cloud  3.You can configure it via eweb  Best regards, Steve |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 5
