EW-300 Pro in Repeater Mode

Hi.  I have 3 of these units on 1 project.  I want one network seen with seamless handover to the nearest AP when moving around.  2 devices are in router mode and seem to be handing over properly.  I am having an issue configuring the 3rd one for repeater mode as I cannot connect a cable to it where it sits.  I added to project by connected to ISP router to WAN port and it adopts.  Then login via EWEB and change mode to repeater and that's where I get stuck.  It wants me to remove from WAN port but then I lose connection to scan for networks.  How do I do this properly?

Dear sir

You can try to configure wireless repeater for this router via this guide on page 35: https://reyee.ruijie.com/en-global/resources/preview/Web-based-Configuration-Guide-ReyeeOS-1204/
You need to unplug WAN port of the router to avoid loop when you configure it to wireless repeater mode, and you can connect to its LAN port so that you can still access the router to configure it when you unplug the WAN port.




Best regards
Jenny

GTAC-Jenny replied at 2024-8-26 14:57
Dear sir

You can try to configure wireless repeater for this router via this guide on page 35: http ...

Hi. this works but does not show on portal for administration?

User 61041 replied at 2024-8-27 01:24
Hi. this works but does not show on portal for administration?

Dear  sir,

If the device is configured as a wireless repeater, you can check the status of the device on the main router.


Home page main router:


Main router > Home page  > More options > Repeaters

thank you for all the assistance - all working