Need WiFiDog Auth Implementation Guide

I need to enable WiFiDog Auth in my Ruijie AP. What are the requirements and basic steps for this?

Dear Sohail,
To configure WiFiDog Auth on RG-AP820-L(V2), you may refer to this configuration guide book:

https://www.ruijienetworks.com/support/documents/slide_rg-wlan-series-access-points-web-based-configuration-guide-en/?page=html&keyworks=wifidog



Best regards,
Lex

GTAC-Lex replied at 2024-8-22 14:59
Dear Sohail,
To configure WiFiDog Auth on RG-AP820-L(V2), you may refer to this configuration guide  ...

Thank you. Let me check the configuration guide book and get back to you.

GTAC-Lex replied at 2024-8-22 14:59
Dear Sohail,
To configure WiFiDog Auth on RG-AP820-L(V2), you may refer to this configuration guide  ...

Hi.

I have added the information in my Ruijie AP WiFiDog Authentication settings.

For portal server, I am using wifidog laravel auth server that is setup on a hosted server.

For NAS IP, I have setup a Ubuntu 22.04 virtual machine on same network subnet as my Ruijie AP.

The Auth server says pong and returns auth code 1 after user login and pressing start internet button which sends token to gateway but internet is not opened by the Ruijie AP.

Please guide me what I am doing wrong.