Divice alarm insufficient power
|
My divice has an alarm severity " Insufficient Power ". Pls help me that reason why and what shout i do. |
|
Dear sir Please check the AP power supply, whether it meets the standard to power on the AP. RAP2200(E) can support 802.3af/at PoE, 12V/1.5A DC Adaptor.  If you use standard power supply, but the alarm when the power supply can support standard 802.3at protocol still prompts. You can try to change the AP power mode to 802.3at manually on the following page:  Note: You can change to 802.3at power mode only when the power supply can support standard 802.3at protocol, otherwise the AP will not be powered on normally. Best regards Jenny |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
