|
Applied Scenarios The native VLAN is used to carry untagged traffic on a trunk port. It allows devices that do not support VLAN tagging to communicate with each other. Configuration Steps a) Configure native vlan on the switch port via CLI: For example, run the following command to configure VLAN 10 as a native VLAN in interface G0/1: Ruijie(config)#int g0/1 Ruijie(config-if-GigabitEthernet0/1)#switchportmode trunk Ruijie(config-if-GigabitEthernet 0/1)#switchporttrunknative vlan 10 b) Configure native vlan on the switch port viaeweb: For example, configure vlan 10 to the native vlanon interface G0/1: Click VLAN> Trunk Port, select a port,specify Native VLAN and Allowed VLAN, and click Save. The "Configuration succeeded." message is displayed. In this case, the newly added trunk portis displayed in the trunk port list.  |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 5
