|
When there are wireless 802.1x or web issues, you need capture packet to check. You can refer to the following guide to capture the auth packet on the AC. 1. Topology  Ruijie(config)#monitorsession 1 source interface gigabitEthernet 0/3both----you can change the port by enter Ruijie(config)#monitorsession 1destination interface gigabitEthernet 0/1switch 3. After the PC connects to the AC, open the wireshark, choose the interfaces to capture from, then start.  |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 6
